Pump Hayward Tristar SP32161E2 (220 V, 23.5 m3/h, 1.5 HP)

• Body: heat-resistant polypropylene fiber
• Motor: enclosed stainless steel
• Pump protection class: IP55
• Max. fluid temperature: +35°C
• Min. liquid temperature: +4°С
• Engine speed: 2900/min
• Number of phases: 1
• Power: 220V
• Current: 4/2.3 A
• Allowed salt concentration: up to 5 g/l < /li>
• Can be installed above water level: yes
• Pre-filter with transparent screw cap: 1/4 turn

The equipment is designed for clean water and does not replace drainage pumps. Please observe the following rules:

• Sand is a strong abrasive. Suction of a small amount of sand is acceptable, but it accelerates component wear.
• Simultaneous suction of large accumulations of sand or dirt (especially during pool opening after winter) blocks the impeller, leads to overheating and subsequent motor burnout, and voids the warranty.
• If the pool is heavily contaminated, vacuum the debris with a manual pool cleaner using slow movements, and make sure to set the filter to the Waste mode so the dirt goes directly to the drain.