Pump Aquaviva LX STP250T (380 V, 27 m3/h, 2.5 HP), AISI 316 shaft

• Guidelines
• Collapsible scheme

• Pump housing: thermoplastic
• Shaft material: stainless steel AISI 316
• Effective prefilter
• Protection system against draining residual water at every stop
• Maximum liquid temperature: +50°C
• Minimum liquid temperature: +4°C
• Maximum air humidity: up to 95%
• Engine speed: 2900/min
• Insulation class: F
• Water protection class: IP55
• Thermal protection
• Overheat protection

The equipment is designed for clean water and does not replace drainage pumps. Please observe the following rules:

• Sand is a strong abrasive. Suction of a small amount of sand is acceptable, but it accelerates component wear.
• Simultaneous suction of large accumulations of sand or dirt (especially during pool opening after winter) blocks the impeller, leads to overheating and subsequent motor burnout, and voids the warranty.
• If the pool is heavily contaminated, vacuum the debris with a manual pool cleaner using slow movements, and make sure to set the filter to the Waste mode so the dirt goes directly to the drain.