Pump Emaux SS100T (220 V, 13.8 m3/h, 1 HP)

• Instruction

• The timer allows you to set the required time to start the pump and the duration of operation: from 2 to 24 hours
• Backup memory battery: up to 72 hours
• Motor : asynchronous, two-pole
• Insulation class: 130 (V)
• Shaft and mechanical seal made of SS 316

The equipment is designed for clean water and does not replace drainage pumps. Please observe the following rules:

• Sand is a strong abrasive. Suction of a small amount of sand is acceptable, but it accelerates component wear.
• Simultaneous suction of large accumulations of sand or dirt (especially during pool opening after winter) blocks the impeller, leads to overheating and subsequent motor burnout, and voids the warranty.
• If the pool is heavily contaminated, vacuum the debris with a manual pool cleaner using slow movements, and make sure to set the filter to the Waste mode so the dirt goes directly to the drain.