Pump Hayward HCP10301E2 KA300 M.B (220 V, 48 m3/h, 3 HP)

• Housing: thermoplastic + fiberglass
• Impeller: noryl + fiberglass
• Suitable for use with sea water: yes
• Maximum water temperature: up to +50°C
• Maximum pressure: up to 3 bar
• Working pressure: up to 2.5 bar
• Noise level: 65.8 dB
• Motor speed: 2850 rpm
• Protection classes: IP55, F
• Electrical characteristics: 220 V/50 Hz
• The manufacturer reserves the right to make changes to the package, design and characteristics at any time that do not impair the quality of the goods, without mandatory notice to the buyer

The equipment is designed for clean water and does not replace drainage pumps. Please observe the following rules:

• Sand is a strong abrasive. Suction of a small amount of sand is acceptable, but it accelerates component wear.
• Simultaneous suction of large accumulations of sand or dirt (especially during pool opening after winter) blocks the impeller, leads to overheating and subsequent motor burnout, and voids the warranty.
• If the pool is heavily contaminated, vacuum the debris with a manual pool cleaner using slow movements, and make sure to set the filter to the Waste mode so the dirt goes directly to the drain.