Pump KRIPSOL Ninfa NK 33 (220 V, 8.4 m3/h, 0.33 HP)

• Pump housing made of thermoplastic
• Fiberglass corrugated impeller
• AISI 303 stainless steel sleeve
• Filter basket made of white plastic
• Pre-filter cover made of transparent polycarbonate
• Closed from the outside with a hinged cover with O-ring, hinged with AISI 304 stainless steel bolts
• Connection : Outer 2'' - Inner 1 1/4''

The equipment is designed for clean water and does not replace drainage pumps. Please observe the following rules:

• Sand is a strong abrasive. Suction of a small amount of sand is acceptable, but it accelerates component wear.
• Simultaneous suction of large accumulations of sand or dirt (especially during pool opening after winter) blocks the impeller, leads to overheating and subsequent motor burnout, and voids the warranty.
• If the pool is heavily contaminated, vacuum the debris with a manual pool cleaner using slow movements, and make sure to set the filter to the Waste mode so the dirt goes directly to the drain.