Pump Aquaviva WTC150-CA (220 V, 24 m3/h, 1.5 HP)

• Built-in pneumatic switch. The handset and pneumatic button are purchased separately
• Body: thermoplastic
• Motor: stainless steel steel
• Max. water temperature: up to +50°C
• Rec. medium temperature: up to +50°C
• Max. working pressure: 0.3 MPa
• Protection class: IP55
• Insulation class: F
• Electrical specifications: 220 V/50 Hz
• Current: 5.8 A

The equipment is designed for clean water and does not replace drainage pumps. Please observe the following rules:

• Sand is a strong abrasive. Suction of a small amount of sand is acceptable, but it accelerates component wear.
• Simultaneous suction of large accumulations of sand or dirt (especially during pool opening after winter) blocks the impeller, leads to overheating and subsequent motor burnout, and voids the warranty.
• If the pool is heavily contaminated, vacuum the debris with a manual pool cleaner using slow movements, and make sure to set the filter to the Waste mode so the dirt goes directly to the drain.