Pump Hayward HCP10251E KA250 M.B (220 V, 44 m3/h, 2.5 HP), discount

• Guidelines
• Collapsible scheme

• Body: thermoplastic + fiberglass
• Impeller: Noryl + fiberglass
• Sea water suitable: yes
• Maximum water temperature: up to +50°C
• Maximum pressure: up to 3 bar
• Working pressure: up to 2.5 bar
• Noise level: 65.2 dB
• Engine RPM: 2850 rpm
• Protection classes: IP55, F
• Electrical data: 230V/50Hz/12.4A

The equipment is designed for clean water and does not replace drainage pumps. Please observe the following rules:

• Sand is a strong abrasive. Suction of a small amount of sand is acceptable, but it accelerates component wear.
• Simultaneous suction of large accumulations of sand or dirt (especially during pool opening after winter) blocks the impeller, leads to overheating and subsequent motor burnout, and voids the warranty.
• If the pool is heavily contaminated, vacuum the debris with a manual pool cleaner using slow movements, and make sure to set the filter to the Waste mode so the dirt goes directly to the drain.