Pump Hayward PL 81005E2 IE2 (220 V, 13 m3/h, 0.75 HP)

• Motor: enclosed stainless steel
• Electrical characteristics: 220 V/50 Hz/3.4 A
• Noise level: 70 dB
• Max liquid temperature: +50°C
• Min liquid temperature: +4°C
• Pressure: up to 2 bar
• Motor speed: 2900 RPM
• Allowed salt concentration: up to 5 g/L
• Can be installed above water level
• The manufacturer reserves the right to make changes to the configuration, design, and specifications, without affecting product quality, and without prior notice to the customer

The equipment is designed for clean water and does not replace drainage pumps. Please observe the following rules:

• Sand is a strong abrasive. Suction of a small amount of sand is acceptable, but it accelerates component wear.
• Simultaneous suction of large accumulations of sand or dirt (especially during pool opening after winter) blocks the impeller, leads to overheating and subsequent motor burnout, and voids the warranty.
• If the pool is heavily contaminated, vacuum the debris with a manual pool cleaner using slow movements, and make sure to set the filter to the Waste mode so the dirt goes directly to the drain.