Pump Hayward PL 81006E2 IE2 (220 V, 15 m3/h, 1 KM)

• Housing: heat-resistant polypropylene fiber
• Motor: closed stainless steel
• Electrical parameters: 220 V/50 Hz/4 A
• Noise level: 70 dB
• Pump protection class: IPX5
• Max. liquid temperature: +50°C
• Min. liquid temperature: +4°С
• Pressure: up to 2 bar
• Motor speed: 2900 rpm
• Number of phases: 1
• Permissible salt concentration up to 5 g/l
• Can be mounted above the water level

The equipment is designed for clean water and does not replace drainage pumps. Please observe the following rules:

• Sand is a strong abrasive. Suction of a small amount of sand is acceptable, but it accelerates component wear.
• Simultaneous suction of large accumulations of sand or dirt (especially during pool opening after winter) blocks the impeller, leads to overheating and subsequent motor burnout, and voids the warranty.
• If the pool is heavily contaminated, vacuum the debris with a manual pool cleaner using slow movements, and make sure to set the filter to the Waste mode so the dirt goes directly to the drain.